Difference: McForth (16 vs. 17)

Revision 172019-01-20 - PeterSchmid

Line: 1 to 1
 
META TOPICPARENT name="WebHome"
%DASHBOARD{ section="banner"
Line: 200 to 200
 

Serial EEPROM Connected to Centronics Connector (Switches and LEDs)

Changed:
<
<
Sharing the LED and Switch port, you loose two LEDs and one switch. Possible conflict with the bootstrap loader, if there is a read sequence (CS and read pattern 0000 0011). To prevent this, set the EEPROM into HOLD state e.g. with the WAIT/ signal.
>
>
Sharing the LED and Switch port, you loose two LEDs and one switch. Possible conflict with the bootstrap loader, if there is a read sequence (CS and read pattern 0000 0011). To prevent this, set the EEPROM into HOLD state e.g. with the WAIT signal.
 
SPI MC (Master) 25LCxxxx (Slave) Interface
Changed:
<
<
MISO J2.1 /IN EF4 2 SO diode e.g. 1N4148
>
>
MISO J2.1 IN EF4 2 SO diode e.g. 1N4148
 
MOSI J2.11 O7 LED7 5 SI direct
CLK J2.10 O6 LED6 6 SCK direct
Changed:
<
<
CS J2.12 O5 LED5 1 CS/ direct
>
>
CS J2.12 O5 LED5 1 CS direct
 
  P4.3 VDD 8 VCC +5V capacitor 100 nF to GND
Changed:
<
<
  " 3 WP/ +5V
  J2.14 WAIT/ 7 HOLD/ direct
>
>
  " 3 WP +5V
  J2.14 WAIT 7 HOLD direct
 
  21 GND 4 GND GND
Line: 221 to 221
 
  • BCM 19 (SPI1 MISO) O5
  • BCM 20 (SPI1 MOSI) -
  • BCM 21 (SPI1 SCLK) shutdown
Changed:
<
<
  • BCM 18 (SPI1 CS0) CLR-
  • BCM 17 (SPI1 CS1) WAIT-
>
>
  • BCM 18 (SPI1 CS0) CLR
  • BCM 17 (SPI1 CS1) WAIT
 
  • BCM 9 (SPI0 MISO) IN4
  • BCM 10 (SPI0 MOSI) IN3
Line: 298 to 298
 

Serial EEPROM patched on MC PCB

Changed:
<
<
SPI Mode 0, data is always latched in on the rising edge of SCK and always output on the falling edge of SCK. For CS one output port bis is needed e.g. O7.
>
>
SPI Mode 0, data is always latched in on the rising edge of SCK and always output on the falling edge of SCK. For CS one output port bis is needed e.g. O7 or INP4 to start/end operation (A high-to-low transition on the CS pin is required to start an operation and a low-to-high transition is required to end an operation.finish).
 
SPI MC (Master) 25LCxxxx (Slave) Interface
Changed:
<
<
MISO /EF2 2 SO direct
>
>
MISO EF2 2 SO direct
 
MOSI D0 5 SI direct
CLK TPB & N1 (OUT2) 6 SCK wired AND; Pullup 10 k, 2 1N4148
Changed:
<
<
CS J2.11 O7 LED7 1 /CS direct
>
>
CS N2 1 CS direct
 
    8 VCC +5V
Changed:
<
<
    3 /WP +5V
  J2.14 WAIT/ 7 /HOLD direct
>
>
    3 WP +5V
  J2.14 WAIT 7 HOLD direct
 
    4 GND GND

Read Byte

Line: 375 to 375
 
Spare Time Gizmo’s ELF2K ROM for RaspiElf

Spare Time Gizmo’s ELF2K ROM for RaspiElf

Changed:
<
<
Herb Johnson's ELF 2K ROM for 1802 Membership Card
>
>
For details see Herb Johnson's ELF 2K ROM for 1802 Membership Card
 
Changed:
<
<
v88.hex from the Spare Time Gizmos web site.
>
>
v88.hex from the Spare Time Gizmos web site.
 
pi@cosmac:~/elf/elf2k $ cp v88.hex v88.hex.org

 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2024 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback